pcsoft.us.windevCopyright 2026, PC SOFT22 Feb 2018 14:57:00 Z22 Feb 2018 11:34:00 ZHi Folks, I have inherited a report which just has a body block, and its all I have to work with! For info it is called as a sub report from another report. In the body block the first line has some labels and the second line aligned under each label is a field containing the data for that label. The result of the above is that I get a label line then a data line then a label line then data line and so on it doesnt look nice and is confusing and messy on large volumes of data. To tidy it up a bit I want to suppress the labels after the very first label line has been output which I have managed by making the labels on every subsequent label line invisible, the down side is that it leaves a blank line where the labels would have been had I not made them invisible. How do I suppress this blank line in the report, basically ignore outputting it ?30WEBDEVen_UShttps://forum.pcsoft.fr/es-ES/pcsoft.us.windev/64669-reports-report-writer-suppressing-output/read.awpmoderateur@pcsoft.fr (El moderador)webmaster@pcsoft.fr (El webmaster)guestpcsoft.us.windevhttps://forum.pcsoft.fr/es-ES/pcsoft.us.windev/64669-reports-report-writer-suppressing-output-64676/read.awp22 Feb 2018 14:57:00 ZWhy don't you put the labels in the page header instead of the body? I don't know if it works but if you need to keep the lab…https://forum.pcsoft.fr/es-ES/pcsoft.us.windev/64669-reports-report-writer-suppressing-output-64676/read.awphttps://forum.pcsoft.fr/es-ES/pcsoft.us.windev/64669-reports-report-writer-suppressing-output-64676/read.awpReports - Report Writer - Suppressing output?