|
| [WD19] Zoomed code window problems |
| Iniciado por guest, 23,ene. 2015 19:18 - 3 respuestas |
| |
| | | |
|
| |
| Publicado el 23,enero 2015 - 19:18 |
Hi,
in one of the last webinars I saw, that code window can be zoomed and now I tested that:
Changed Display to 150% and was glad reading large size.
I wanted to Change to 120%, but this choice is not available.
Totally down in the drop down list I found 'adapted' which obviously zoomed to window size.
Then wanted to debug and the left bar in the code window was absent, so could not set a breakpoint.
Changed back to 100%, then the bar is visible again, but size of code text is as small so you Need something like electron microscope to read it.
result: Adapted, 10% and 25% selection you can read text but no use of left bar for breakpoints.
All equal or greater than 50% results in that micro font which is not readable.
Anyone out there who knows how to get back to Standard Display?
thanks for any hints.
Erik |
| |
| |
| | | |
|
| | |
| |
| Publicado el 24,enero 2015 - 16:09 |
Hi,
changed to another Project and came back to my Problem Project one day later. Code text is now in big letters and therefore readable again.
But changing zoom now doesn't change letter size at all but only the width left to the code (bar with debug info and date and author Display, if enabled). So with 50% for example author and date cannot be shown completely, but with 150% it does so.
Nevertheless I would like Change the font size with the zoom again :confused:
Erik |
| |
| |
| | | |
|
| | |
| |
| Publicado el 24,enero 2015 - 17:05 |
Hi Erik
I haven' t played with this particular settings... However, in my experience, settings are stored either in the .env file in the project directory (if linked to a project), and you can delete that file to restore default settings, or in the registry in the pcsoft key, and you can delete that key to get the general default settings too
Best regards |
| |
| |
| | | |
|
| | |
| |
| Publicado el 24,enero 2015 - 18:29 |
Hi Fabrice,
thanks for the info, I actually found the value for the zoom in the registry, changed it and the change also appears in Windev, but the size of the font in code Editor is always the same.
Best regards
Erik |
| |
| |
| | | |
|
| | | | |
| | |
|