|
| Border for bodycontents in Reports |
| Iniciado por guest, 22,mar. 2015 14:38 - 4 respuestas |
| |
| | | |
|
| |
| Publicado el 22,marzo 2015 - 14:38 |
Hi all,
I am facing a problem in Reports. I need to add an outside border to the entire contents in body part of the report..I tried to add border to all individual cells,but gives a weird look..I also tried to add line Shape controls to the body part,it also didn't give the desired effect..actually what I want is a full outside border. I have attached an image in which i border the contents using paint to show what i need.
[attachment 1397 2.png] |
| |
| |
| | | |
|
| | |
| |
| Publicado el 22,marzo 2015 - 17:30 |
Amal,
Set the board on the body block itself.
DW |
| |
| |
| | | |
|
| | |
| |
| Publicado el 23,marzo 2015 - 07:06 |
Hi DW,
Thank you for your response..
But it didnt work..see the image attached..when I tried to add border the body block ,I got the result like this...
Is there any other solution???
[attachment 1399 3.png] |
| |
| |
| | | |
|
| | |
| |
| Publicado el 23,marzo 2015 - 10:11 |
Hi,
To be quite honest I`m not shure that you can do that with R & Q, at least without a lot of work.
Other report generators (Fomin, List & Label) has a "Page form" where you can draw boxes and other stuff that is supposed to be behind the actual printout.
I have developed an invoice program with WinDev and pretty soon in the development cycle I discovered that I needed a third party report generator.
I choosed List & Label but Devexpress has a good one to.
I attach a couple of screenshots from the report-designer so you know what I`m talking about:
1. A modern designer
2. Possibillities to do this:
Cheers
Tor-Bjarne |
| |
| |
| | | |
|
| | |
| |
| Publicado el 23,marzo 2015 - 11:29 |
Amal,
Use a break above and below. Use the bottom line of the break header and the top line of the break footer make tem 2 pixels each when done setting them up. then use the right and left only of the body.
DW |
| |
| |
| | | |
|
| | | | |
| | |
|